ANDEROL® 786

网址：http://www.deseme.com.ar/pdfs/industrial/greases/anderol_786.pdf
SYNTHETIC EXTREME PRESSURE GREASE
GENERAL INFORMATION
ANDEROL 786 is a diester-based, NLGI 2 grade grease with tackifiers that is uniquely formulated to provide excellent
load carrying at high speeds.
For more information please refer to the
relevant Material Safety Data Sheet
accompanying each product.
®ANDEROL is a reg. trademark of ANDEROL COMPANY.
This information is furnished without warranty, representation, inducement,
or license of any kind, except that it is accurate to the best of OUR
knowledge or obtained from sources believed by ANDEROL to be
accurate. ANDEROL does not assume any legal responsibility for use of
reliance upon it. Only chemists or chemically qualified lab technicians
should carry out tests. Before using any chemical, read its label and
Material Safety Data Sheet.
TYPICAL PROPERTIES:
PROPERTIES TEST METHOD RESULTS
NLGI Number
Worked Penetration
Worked Stability, 100,000 Strokes
Dropping Point, °F (°C)
Oil Separation, 30 hrs @ 212°F (100°C), %
Evaporation, 22 hrs @ 210°F (99°C), %
Humidity Cabinet, hrs, minimum
Four-Ball Wear, 1200 rpm, 167°F (75°C), 40 Kg, 1 hr, mm
Four-Ball EP, Weld Point, Kg
Specific Gravity, 60°F (15.6°C)
---
ASTM D 217
ASTM D 217
ASTM D 566
FTMS 791b, No.321.2
ASTM D 972
ASTM D 1748
ASTM D 2266
ASTM D 2596
ASTM D 1480
2
300
355
525 (274)
0.5
0.9
200
0.6
210
0.94
APPLICATIONS
Typical applications for ANDEROL 786 include the following:
§ Gear lubrication § Helicopter transmission couplings
§ Speed reducers § Mechanical drive couplings
§ Ball and roller bearings § Office, computing, and accounting equipment
§ Sleeve bearings § Slides, cams, pulleys, and conveyors
§ General maintenance lubrication § Textile manufacturing equipment
ANDEROL 786
ADVANTAGES
·  Resistance to water and chemical washout
·  Excellent anti-wear and extreme pressure protection (EP)
·  Excellent corrosion protection
·  Resists flying off from high speed moving parts
·  Normal operating range of 0 to 300°F (-18 to 149°C)
COMPATIBILITY
The following seals, paints, and plastics are recommended for use in contact with ANDEROL® Company Synthetic
Lubricants. Materials not recommended are also shown. For more information on other materials, see our "Compatibility
Guide."
RECOMMENDED - Viton, High Nitrile Buna N, Teflon, Epoxy Paint, Oil-Resistant Alkyd, Nylon, Delrin, Celcon, PBT
NOT RECOMMENDED - Neoprene, SBR Rubber, Low Nitrile Buna N, Acrylic Paint, Lacquer, Polystyrene, PVC, ABS
A786: 3/14/01
ANDEROL®
Specialty Lubricants
ANDEROL COMPANY
PO Box 518, 215 Merry Lane
East Hanover, New Jersey USA
Tel: 888-ANDEROL
Or Tel: (973) 887-7410
Fax: (973) 884-3825
E-mail: info2@anderol.com