ANDEROL 568
Synthetic Compressor Lubricant Product Data Sheet
ANDEROL 568 is an ISO 68 synthetic di-ester based compressor lubricant specifically
designed to provide longterm lubrication in air and process gas compressors.
The base chemistry of this synthetic product eliminates varnish formation and separator
blocking whereas the anti-oxidants provide longer drain intervals.
The superior oxidation and wear resistance permits Anderol to put this fluid in the most severe
applications where other products might fail.
ADVANTAGES / BENEFITS COMPATIBILITY APPLICATION
ANDEROL synthetic lubricants are the only
long-life synthetic lubricant with over 60 years
of successful performance.
Fewer oil changes
Longer service life and greater protection of
compressor components
Wide operating temperature range
Increases maintenance intervals
Very high oxidation resistance
Lower oil consumption
Eliminates lacquering and deposits
Reduces energy consumption
The following seals, paints and plastics are
recommended for use in contact with Anderol
Synthetic Lubricants. Materials not
recommended are also shown. For more
information on other materials see our
‘Compatibility Guide’.
RECOMMENDED :
Viton, High Nitrile Buna N, Teflon, Epoxy Paint,
Oil-Resistant Alkyd, Nylon, Delrin, Celcon, PBT
NOT RECOMMENDED:
Neoprene, SBR Rubber, Low Nitrile Buna N,
Acrylic Paint, Lacquer, Polystrene, PVC, ABS
Anderol 568 is a synthetic compressor
lubricant suitable for screw, vane and piston
compressors requiring very good wear and
oxidation resistance. The low pour point and
high film strength provides special protection
when operating in start/stop mode in cold
weather conditions, e.g. snow blowers
FOR MORE INFORMATION PLEASE REFER TO THE RELEVANT MATERIAL SAFETY DATA SHEET
APPROVALS / REGISTRATIONS
ANDEROL BV
Punterweg 21 A
6222 NW MAASTRICHT
The NETHERLANDS
Tel No.: +31 (0)43 352 41 90
Fax No.: +31 (0)43 352 41 99
www.anderol-europe.com
This information is furnished without warranty, representation, inducement, or license of any kind except that it is accurate to the best of OUR knowledge or obtained from sources believed by
ANDEROL to be accurate. ANDEROL does not assume any legal responsibility for use of reliance upon it. Only Chemists or chemically qualified lab technicians should carry out tests. Before using any
chemicals, read its label and Material Safety Data Sheet.
PROPERTIES TEST METHOD ANDEROL 568
Appearance @ 20°C
Viscosity @ 40°C, cSt
Viscosity @ 100°C, cSt
Viscosity Index
Density @ 15°C, kg/l
Total Acid Number, mg KOH/g
Flash Point, °C
Fire Point, °C
Pour Point, °C
Demulsibility @ 54°C,min
visual
ASTM D-445
ASTM D-445
ASTM D-2270
ASTM D-1298
ASTM D-664
ASTM D-92
ASTM D-92
ASTM D-97
ASTM D-1401
Clear Yellow Liquid
72.1
9.7
115
0.956
0.09
230
250
-35
20 |
