ANDEROL HTFG-2
General Purpose Grease For Elevated Temperatures NLGI-2 Product Data Sheet
ANDEROL HTFG 2 is a high temperature polytetrafluor ethylene concentrate (PTFE) thickened
grease based on synthetic oil.
ANDEROL HTFG 2 is chemical resistant and provides lubrication at temperatures up to 300°C.
It is NSF (H1) registered for use in applications where incidental food contact might occur.
APPLICATIONS / ADVANTAGES REGISTRATIONS / APPROVAL HANDLING AND STORAGE
Food Grade Hight Temperature Grease
Applications where Elastomer compatibility is
a must
Temperature charged conveyors
Baking Ovens
Drying, lacquering and enamelling furnaces
Tunnel furnace trolleys
Hot gas fans
Textile tenter frames, foil stretching machines
Valves and fittings for Oxygen (up to 60°C
and pressure limit of 100 bar)
Bicycle shifters, Bycycle suspension
Fishing reels
CD/DVD drives (main bearing)
ANDEROL Lubricants are approved,
recommended and field tested by many
OEM’s in the Food processing, bottling,
canning, meat processing and
pharmaceutical industries.
ANDEROL lubricants generally present little
hazard in normal handling if ordinary care is
exercised. If spilled, cover with inert,
absorbent material and remove. Flush the
area with water.
Although ANDEROL lubricants are not highly
flammable, they will burn and should be kept
away from open flames. In case of fire, use
water spray, foam, carbon dioxide, or dry
chemical.
ANDEROL lubricants should be stored
preferably in protected locations to prevent
contamination. Do not re-use drums; flush
and send to re-conditioner.
FOR MORE INFORMATION PLEASE REFER TO THE RELEVANT MATERIAL SAFETY DATA SHEET
APPROVALS / REGISTRATIONS
ANDEROL BV
Punterweg 21 A
6222 NW MAASTRICHT
The NETHERLANDS
Tel No.: +31 (0)43 352 41 90
Fax No.: +31 (0)43 352 41 99
www.anderol-europe.com
This information is furnished without warranty, representation, inducement, or license of any kind except that it is accurate to the best of OUR knowledge or obtained from sources believed by
ANDEROL to be accurate. ANDEROL does not assume any legal responsibility for use of reliance upon it. Only Chemists or chemically qualified lab technicians should carry out tests. Before using any
chemicals, read its label and Material Safety Data Sheet.
PROPERTIES TEST METHOD ANDEROL HTFG-2
Thickener
Color
Type of Base Oil
Operating temperature for long-term lubrication, °C
Short term admissible temperature peak value, °C
Dropping Point, °C
Worked Penetration
Base Oil Viscoity at 40°C
Water resistance
4-ball weld load
Designation
DIN ISO 2176
DIN ISO 2137
DIN 51.562
DIN 51.807-01
DIN 51.350/4
DIN 51.502
PTFE
White
Synthetic (PFPE)
-40 to 280 °C
+300°C
Not dropping
265 to 295 0.1 mm
Approx. 500 mm²/s
0-90
3600 N
KFK 2 U-40 |
